December 2016
Columns
Reliability: Troubleshoot hot bearings in hot pumps
The reliability engineering unit supervisor (REUS) working at a 400-Mbpd refinery wrote that he was greatly concerned about a bearing temperature excursion. He realized that certain rules of thumb had been handed down to his maintenance employees, and that not all of these conveyed the same numbers and guidance.
The Author
Heinz P. Bloch resides in Montgomery, Texas. He retired as Exxon Chemical’s Regional Machinery Specialist for the U.S. and has authored or co-written more than 780 publications, among them 23 comprehensive books on practical machinery management, failure analysis, failure avoidance, compressors, steam turbines, pumps, oil mist lubrication and optimized lubrication for industry. Mr. Bloch holds BS and MS degrees (cum laude) in mechanical engineering from the Newark College of Engineering (NCE). He is one of 10 inaugural inductees into NCE’s Hall of Fame, which honors its most distinguished alumni.
Related Articles
- Enhance rotating equipment reliability: Implementing a bad actor program in the oil and gas industry
- Common challenges in risk-based inspection for piping: Insights from experience
- Hydrocarbon value chain optimization: Non-CAPEX opportunities to improve gross margins for the downstream sector—Part 2
Comments